Since October 2025, DAF offers factory five-axle chassis with a dual drive tandem (or in short, 10×4 trucks). Previously, an XD- or XF-series 8×4 chassis-cab had to be brought to a specialist, more specifically Ginaf or Veldhuizen Trucks, for an extra axle. DAF uses the designation FAF for the 10×4*6 drivetrain, which means it has a counter-steering tag axle.
This XF-FAF demo truck with a day cab is powered by the 12.9 liter MX-13 engine, good for 530 DIN-hp. The XD and XF 10×4*6 trucks have parabolic leaf springs on the front axles and air suspension on the tridem, completed with a hydraulic steering system on the tag axle. Planetary drive axles are optional.
The demo truck’s on-road, legal maximum gross weight is 47 tonnes (103,600 lbs), whereas the factory rating is 54 tonnes (119,000 lbs). Its registered, legally allowed payload capacity is almost 29 tonnes (63,900 lbs). Heavy going, literally.
An image of the XF-series’ standard ‘Hexagon’ dashboard. There’s no gear lever, as a ZF TraXon AMT is the only transmission available. Evidently, opting for a day cab these days doesn’t necessarily mean the driver has to put up with a cramped, penalty box interior.
The DAF is equipped with a Tibeg insulated dump body, suited for transporting hot asphalt. The tag axle’s static weight limit is 26 tonnes (57,300 lbs), especially significant when the truck has a roll-off system.
This picture was taken in the same yard at the DAF plant in Eindhoven, showing a partially raised dump body and a fully raised tag axle. The tank behind the cab contains the hydraulic oil.
Here’s an identical DAF in the livery of the Mandemakers hauling company, yet with the standard XF bumper rather than the three-piece steel bumper on the demo truck (and standard on the XFC-series). Also, the owner had the front fenders painted in the same color as the cab, and that simply looks better. The insulated dump body was built by AJK from Belgium.
On a general note, when comparing such a 10×4*6 drivetrain with an equally sized, traditional 10×4 chassis (three steering axles ahead of the drive axles), the 10×4*6 truck has a smaller turning radius.
Over to Switzerland, where straight trucks with five axles are also widely used. The DAF XF 10×4*6 chassis-cab in the picture has a Moser Rockbox dump body. The country’s weight limit for such a setup is 40 tonnes (88,200 lbs), which is a piece of Swiss roll cake for any five-axle heavyweight.































Nice tipper, nice trucks to drive though I prefer a manual 18 speed RR a lot were specced with here.
A brand new XF 530 from NZ, I assume the ‘six-wheeler’ has a 6×4 drivetrain, which means it’s an XF 530 FAT (with a low roof sleeper cab).